JORESTECH 12" (300mm) Shrink Wrapper Sealer With Roll Base 110 Volts

Features: Model SHR-300 11 5/8 inches (300 mm) sealing length. Simple to use - No Operator Training Needed. Table top design supported with anti-slip rubber stands. Sealing indication light. Round type heating wire. Seals and cuts uniformly every time. No warm-up time necessary. (Impulse Sealing System) Rugged All-Metal Construction. Powder-coated die-cast construction. Timer for Sealing Control (From 0 to 2 Sec) Stainless-steel roll base for center-folded shrink film roll. Separator bar. Separates upper and lower layer of the center-folded film. Equipped with a switch for self cleaning of heating element. Plastic handle conveniently placed at an end of the sealing arm. Holds a Polyolefin roll with maximum width of 11 Inches. This machine has a production capacity of approximately 8-12 pcs/min, depending on operator speed. Wire Specifications: Diameter: 0.5 mm/0.0197 inch Resistance: 7.258 Ohms/m / 2.212 Ohms/foot Type: Round Wire. Machine Includes: Replacement Kit with: 2 Heating elements. Adhesive PTFE strip. 6 feet. US standard grounded plug 110 VAC. Other Specifications: Voltage: 110 VAC / 50-60 Hz Impulse Power: 1000W (heat element does not heat while machine is not sealing, thus, energy draw is minimal)

• 12" Shrink Wrapper Sealer With Roll Base
• 11 5/8 inches (300 mm) sealing length
• Table top design supported with anti-slip rubber stands
• No warm-up time necessary. (Impulse Sealing System)
• Stainless-steel roll base for center-folded shrink film roll.